|
|
BLANCHARD MODEL 11AED20 ROTARY SURFACE GRINDER SERIAL NUMBER: 15827 You Have Probably Never Seen A Machine Such As This, As It Is So Rare. Having This Blanchard In Your Factory When Engineers Walk Through Will Show Them That You Are Capable Of State Of The Art Machining. This Grinder Is A Rare Find In The Market Place Today. I Do Not Believe There Has Ever Been One Of These For Sale On The Internet. It Was In A Captive Shop, Used Very Little And Is A One Owner Machine! Approximate Year: 1991 Specifications: Magnetic Chuck Diameter: 20" Concentric Pole Spacing; .5" Swing Capacity Inside Waterguards: 21" Grind To Center Diameter: 21" Vertical Range Under New CDTL Segments: 18" Maximum Unbalanced Work Load On Chuck: 500 Lbs. Chuck Rotation Speed (Variable): 15 To 75 RPM Grinding Wheel Size: 11" x 5" x 9" Grinding Wheel Speed: 1,200 RPM Feed System: Rapid Traverse Rate: 20 IPM Wheel Head Jog Rate: .100 IPM Coarse Feed Rate: .001 To .100 IPM Coarse Feed Mode: Continuous/Impulse Fine Feed Rate: .001 To .010 IPM Fine Feed Mode: Continuous/Impulse Coarse To Fine Changeover Point: 0 To .009" Sparkout Timer: .1 To 10 Minutes Head Position Readout (Digital): 0.000 To 9.999" Field Convertible To Metric-Accepts Up To 3 Point Equipped With: Blanchard Auto Zero II Control (5) Foot Pads Hydroflow Coolant System Electric Power Requirement: 30 KVA Minimum Size Outside Coolant System Required: 75 Gallon 2 HP Chuck Rotation Motor 5.8 Lb-Ft Head Feed Motor (D.C.) .25 HP Table Traverse Motor With Brake 15 HP Grinding Wheel Motor (Currently Wired For 480 Volts) "A" Model Concept: Control Of The Wheelhead Travel, Feed Rates, Chuck Rotation Speeds, Dwelltime, Etc. Is At The Operator's Fingertips. Set Up Controls Are On The End Waterguard At The Loading Position. Two Feed Modes (Continuous Or Impulse) In Both The Fine And Coarse Feed Ranges May Be Changed Without Interrupting The Grind Cycle. This Dual-Rate Feed System Allows Fast Stock Removal At A Coarse Feed Rate, Along With Automatic Change To a Fine Feed Rate For Final Sizing And Finishing. The Dwell Timer Provides Controlled Sparkout For Precision Finishes. The Feed Rate Range Is From .001-.100 Inches Per Minute. Chuck Rotation Is Infinitely Variable Between 15 And 75 RPM, and May Be Changed While Grinding. "A" Model Blanchards Are Inch To Metric Convertible In The Field And Will Accept A Variety Of Blanchard In Process Gaging Systems. Cost New In 1991: $143,000.00 U.S.D. Made By Cone-Blanchard Machine Company Supported Today With Parts And Service By Bourn And Koch Copy Of Operator's Manual/Maintenance Instructions And Various Other Books And Prints Included Approximate Dimensions Of Machine: 57" D x 110" W x 86" H On 4" Blocks Approximate Dimensions Of Big Coolant Tank: 80" D x 48" W x 66" H Approximate Dimensions Of Small Coolant Tank: 31" D x 24" W x 28" H Approximate Overall Floor Space: 165" W x 91" D Approximate Total Weight: 10,500 Lbs. Specifications Are Subject To Verification (INVENTORY #12845) |
|
|
|
|
|
|