|
|
JET 24"/33" x 120" CC GAP BED LATHE SERIAL NUMBER: 81400311 Gap Bed - Shaft Lathe - Long Bed! RUNS GOOD Approximate Year: Late 1970's Or Early 1980's, We Believe The First Two Digits Of The Serial Number To Be The Year Specifications: Swing: 24", Over Removable Gap 33" Swing Over Saddle: 17" Width Of Removable Gap: 7 1/2" Distance Between Centers: 120" Spindle Speeds: 25, 51, 68, 93, 133, 166, 237, 330, 425, 590, 840 And 1,500 RPM Thru Hole: 2 5/8" Equipped With: Metric Feeds And Threads Bed Ways Appear To Be Hardened 12" Diameter 3 Jaw Chuck With Chuck Wrench Spindle Foot Brake Cam Lock Spindle Steady Rest Tailstock With Scale (5) Foot Pads Coolant Tank, (Sorry No Pump) Enclosed Starter And Electrics 10 HP, 220/440 Volt, 3 Phase Motor, (Currently Wired For 440 Volts) (Missing Lower Motor Cover) Great For Machine Repair Or A Welding Shop Please See The Photo Of The Left Corner Of The Compound And You Will Notice That It Has Never Been Struck By The Chuck. Normally The Left Hand Corner On Compounds Always Take A Hit. There Is A Very Small Issue With This Jet Lathe. There Is An 1 3/4" Pinion Gear In The Carriage That Drives The Carriage By Way Of A Hand Wheel. A Chip, Or Some Type Of Material Chip, Has Got Into The Gear And Has Created A Build Up Or It Has Burred One Tooth. When This Comes In Contact With The Rack, It Causes It To HanG Up Slightly. It Still Works, But Could Be An Annoyance Issue. It May Be Remedied By Using A Small Pencil Grinder To Remove The Burr, As It Can Be Seen About 7" Away From The End Of The Carriage. Or You Could Either Order A New One From The Factory Or Take The Gear Off And Have A New One Made By A Gear Hobbing Business, As It Is A Straight Simple Pinion Gear. We Are Only Mentioning This So There Is No Surprises When The Machine Is Received. This Lathe Would Sell New As A Special Order Only, For Above $25,000.00 USD Or Moore! Made In Taiwan Approximate Dimensions: 173" L x 43" D x 58" H Approximate Weight: 6,000 Lbs. |
|
|
|
|
|
|